I’ve been setting up my first nas and set up DNS routing from my router to adguard home, which then routes traffic to nginx-proxy-manager, which then routes to the docker container for the intended service. I’ve spent days pulling my hair out, trying to figure out what the issue was - why all my services behind NPM were periodically unreachable on my browser. after a wifi reset on my laptop they’d come back online, but why? today I found out that although my router correctly had the DHCP setting correctly set up to route IPv4 traffic to adguard, there was a separate section in the router settings that handles IPv6 settings, and that this was set up to look for my ISP’s assigned DNS provider. Just posting on the off chance anyone finds this helpful or entertaining. I am extremely tired (I have a 3 month old baby) so please bare with the poor formatting of the post!
I didn’t say it was a security feature. But I also don’t really want my ISP knowing how many devices are in my house.
Depending on how your ISP is doing IPv6, the typical way would just route the entire prefix to your router, and the ISP would not know how many addresses are used, in the sense that there is no table (no neighbor discovery is needed). If your ISP is keeping data of flows from your prefix then it could start counting unique addresses, but there isn’t really good a reason to and it wouldn’t be accurate. Some devices pull and use more than one address, and quiet devices might not get picked up by flows which are typically sampled at a ratio.